Blog With Large Image

Simon Heyworth

"Mit Trinnov höre ich nun endlich, was wirklich in meiner Regie passiert. Ich höre es unverfälschter als je zuvor, was gut ist, aber das System zwingt einen nicht den Raum absolut linear abzustimmen. Mit der Zielkurvenfunktion kann ich den Klang so anpassen, dass ich für meine Kunden eine genau passende, aber auch angenehme Abhörsituation schaffe.“
Simon Heyworth (Simple Minds, George Harrison, Brian Eno, Nick Cave, Imogen Heap)

Lorem ipsum dolor sit amet, consectetur adipiscing elit. Vivamus sit amet porta turpis, sit amet scelerisque urna. Maecenas rutrum erat id urna.

John Doe

Duis placerat rhoncus arcu, sit amet aliquam leo

Altitude 16
Lorem ipsum dolor sit amet, consectetur adipiscing elit. Praesent eu nisi ac mi malesuada vestibulum. Phasellus tempor nunc eleifend cursus molestie. Mauris lectus arcu, pellentesque at sodales sit amet, condimentum id nunc. Donec ornare mattis suscipit. Praesent fermentum accumsan vulputate. Sed velit nulla, sagittis non erat id, dictum vestibulum ligula.

Test is the Best

Audio Alarms Section
This section shows the status of the audio alarms. The alarms listed here are Silence Detec-tion for channels A/B/C/D, Sync alarm, Loss of Digital Input, Loss of Digital Reference, Audio Mismatch and I/O Card (rear panel) detection.
Audio Alarms (Silence Detection)
The Audio signal has decreased below the threshold and timeout specified in the audio con-figuration menu. This alarm will be flagged if silence is caused by a network fault, or the call was dropped on the TX side, or just because the audio source has stopped.
Sync Failure (AutoSync Alarm)
This Alarm indicates a general sync failure in a situation where an excessive amount of pack-ets were dropsubped or out-of-sequence resulting in a gap in the audio stream significant enough to generate the Sync alarm. The different audio algorithms or linear PCM have their particular sync-failure sensitivity.
For aptX® Enhanced, this alarm corresponds to the AutoSync Alarm. AutoSync is a bit pat-tern sent embedded in the aptX® audio stream that allows a very rapid resumption of decod-ing after a gap in the bit stream. This alarm will be flagged if the following conditions occur (for network faults, usually along with other network alarms):
- Mismatch

Audio Alarms Section
This section shows the status of the audio alarms. The alarms listed here are Silence Detec-tion for channels A/B/C/D, Sync alarm, Loss of Digital Input, Loss of Digital Reference, Audio Mismatch and I/O Card (rear panel) detection.
Audio Alarms (Silence Detection)
The Audio signal has decreased below the threshold and timeout specified in the audio con-figuration menu. This alarm will be flagged if silence is caused by a network fault, or the call was dropped on the TX side, or just because the audio source has stopped.Audio Alarms (Silence Detection)
The Audio signal has decreased below the threshold and timeout specified in the audio con-figuration menu. This alarm will be flagged if silence is caused by a network fault, or the call was dropped on the TX side, or just because the audio source has stopped.

Lorem ipsum dolor sit amet, consectetur adipiscing elit. Vivamus sit amet porta turpis, sit amet scelerisque urna. Maecenas rutrum erat id urna.

John Doe

Pages